“Why does the paint on my Jolion show blotchy spots, streaks o r “wrinkling” in certain light o r after rain?”

Home > Gari Forums > Haval Forums > Haval Jolion Forums > Haval Jolion Paint Problems Forums

“Why does the paint on my Jolion show blotchy spots, streaks o r “wrinkling” in certain light o r after rain?”

You’ve observed that the surface of your Haval Jolion’s paint shows uneven spots o r streak‑marks: maybe after rain you see faint circular marks, o r in sunlight you notice a minute texture difference slight wrinkling, sag, o r seeming bubbles on a panel. What could be the underlying causes in the context of Pakistan’s climate e.g., humidity, temperature swings, low‑grade paint o r clear coat, poor body shop repairs o r local re‑spraying? What steps would you take to inspect these spots looking for thickness variation, clear‐coat peel, moisture penetration, difference in surface gloss and decide whether this is a manufacturing/paint defect o r corrosion/repair issue? What corrective action would you advise buffing/polishing, re‑clear‑coat, full panel repaint and when to engage the dealer o r warranty?

Talha Kyanii asked on 18 Oct 2025 13:56:51 pm

1 Answer

21 views |

Talha Kyanii - on 18 Oct 2025 14:01:11 pm

Road‑stone and gravel impact: In Pakistan many roads have loose stones o r sand wheel‑arches and door bottoms are very exposed to stone chips, and chips/flakes can appear naturally.

Factory/paint‑quality issue: Some owners believe that paint adhesion is less robust on Haval cars in Pakistan. For example:

“I had severe paint quality issues on the passenger door that I had fixed in warranty.”
Pakwheels
+1

Lack of protective film on vulnerable zones: If these areas are not protected, initial micro‑chips can expose bare metal o r primer, which then promotes flaking o r peeling.

Poor maintenance o r damage: Repeated abrasion from sand, rain‑sand mix, o r improper cleaning could weaken the edges and cause paint to lift.

Possible inferior primer/substrate preparation in assembly especially local manufacturing might lead to weak adhesion around edges.